ULTRACEPT® OPTIONS, SERVICE, AND MAINTENANCE

Options

 

• Heater for Freeze Protection

• Recycling System
 

• Supply Pumps

• Trailer

• Polishing System

Fig. # 8605-03S

Fig. # 8605-03ST

Fig. # 8605-03F

The Ultracept® System designs are flexible. Shown are the stainless steel and fiberglass models, both on and off the optional trailer. Ultracept® Systems in Stainless Steel are available with flow rates of 2, 3, 5, 10, 25, and 45 GPM. Fiberglass units are only available in 5 GPM models. For higher flow rates, units can be installed in parallel. Please contact your Ultracept® representative for proper sizing. All sizes can be set up as portable units.

Ultracept® Systems are shipped with all internal plumbing and necessary drainage fittings installed.

Service and Maintenance
The purpose of your Ultracept® Oil/Water Separator System is to give you clean water that will meet your requirements no matter how stringent they may be.

Since there are No Moving Parts, No Coalescing Plates to clean and No Filters to change, suggested maintenance is less than 10 minutes a week. Discharges under 10 PPM have been achieved.

We have knowledgeable representatives throughout the country who are available to assist you at anytime.
  Interceptor Section Index   Technical Data Index   Go Back   Go Forward