Case Study/Testimonial and Specifications
Grease+Gard™ Retrofit Skimmer and Grease Recovery Device
"The Solution: Stop grease before it plugs the lines and reaches the environment."

Shari’s had a 20 gallon per minute interceptor installed in-the-floor in their mechanical room. The interceptor was recessed in-the-floor and only connected to their double compartment sink. The pre-rinse was not picked up by an interceptor.

The City of Hillsboro was not happy with Shari’s discharge; they had them pump out the grease interceptor twice a week. With the pre-rinse sink not being hooked up to the interceptor this facility was discharging a lot of grease into the sewer system.

Shari’s had Grease+Gard™ look at their application to see what could be done to bring them in compliance with the city. We were able to take the pre-rinse sink and the double bowl sink and run the two sinks through a solids interceptor, then to the grease interceptor. We were able to take the Grease+Gard™, 8175GG and mount it on top of the grease interceptor.

Now Shari’s was able to remove the solids at the source and remove the grease out of the grease interceptor daily. This allowed Shari’s to go 2 months without pumping out their interceptor.

Grease+Gard™ Retrofit Skimmer
Furnish and install a retrofit Jay R. Smith Mfg. Co. Grease+Gard™ Skimmer figure numbers 8165GG, standard or 8175GG, low profile unit on an existing grease interceptor. The skimmer housing is constructed from type 304 stainless steel and features the Grease+Gard™ belt type skimmer with integral heating element, patented Agitator technology, adjustable timer, mounting plate with gasket and grease reservoir container.

Grease+Gard™ Indirect Solids Interceptor
Furnish and install a Jay R. Smith Mfg. Co. Grease+Gard™ Indirect Solids Interceptor figure number 8960. The solids interceptor is constructed of type 304 stainless steel and features adjustable legs, perforated bottom bucket, and secondary poly mesh strainer. Grease+Gard™ Inline Solids Interceptor Furnish and install a Jay R. Smith Mfg. Co.

Grease+Gard™ Inline Solids Interceptor
Furnish and install a Jay R. Smith Mfg. Co. Grease+Gard Inline Solids Interceptor figure number 8980. The solids interceptor is constructed of type 304 stainless steel and features adjustable legs, perforated bottom bucket, secondary poly mesh strainer and secure cover.